Made in: EU
Model: 8105 anodised
Category: Equipment for football
The transportable goals from the compact range were the conceptual origin of this goal development. However, it was
necessary to construct goals with small packing sizes. Yet, no compromises should be made with regard to the goals’ stability – neither for the goals in the compact range nor the completely welded goals. The longest packing piece is max. 6 m long. Unlike the completely welded goals, for which special hauliers are used for transport, that can only transport a small number of goals per lorry, the environmental load when transporting these goals is comparatively low.
The transportable goals are manufactured from the established oval profiles 120/100 in the crossbar/uprights and ground tubes/ground spars areas. There are two goal corners in the crossbar/uprights area, that connect the crossbar and uprights together with special binding elements. In the ground tubes/ground spars area, there are two more goal corners that connect the ground tubes/ground sparss together with special binding elements. The goal corners are welded as a mitre joint. All four goal corners are identical. This means that the goals are relatively easy to assemble.
The fact that they are straight cuts cannot be seen on the goal as it is screwed together in the crossbar and uprights area and the base tube and base rails area. In the posts/base tube area, the connection takes place with a corner connector weld construction. There are barely any visible mitre joint cuts. The goals are tech. anodised in the crossbar/uprights and ground tubes/ground sparss area and matt silver or white powdercoated. They therefore look different to completely welded goals that are natural polished aluminium. The known net hoops of aluminium tubes 40 mm diameter are used.
The ground frame is provided with 25 mm large holes to attachto the ground.
The goal depth is 1.50 m.
These goals are also delivered exclusively with the proven Safety system net holders.
— extremely stable and precise—fitting aluminium cast corner joints
— reinforced aluminium net hoops
— quick and simple assembly and disassembly
— Safety system net holders
— one hundred percent steady goal, location in ground sockets by use of special wedges
Comply with DFB and FIFA regulations
Standard equipment: Matt silver anodised finish or white powder coated at additional cost.
Cat.—no. 101 anodised
Cat.—no. 1015 white
Incl. “Free hanging net” consisting of galv. steel upright with ground sockets and all tensioning ropes, Safety system net holders, ground sockets – insertion depth 500 mm – with cover and special wedges, acc. to EN 748 and TÜV
Made in: Italy
Category: safety systems for pools
The drowning detection system studies the behaviour of the swimmers at the pool,
immediately identifying any danger situations.
The video cameras in the water probe the pool and capture images that are analyzed in real time by software.
The rescue personnel, thanks to the service monitor, can control all the activities at the bottom of
In the event of drowning danger, the system activates a vibrating acoustic signal on the
hand—held device of the lifeguards, thus allowing immediate intervention in the exact area of the